The test probes are particularly suitable for measurements in hard-to-reach areas or areas with fine PCB structures. Due to the large, stable shaft, the probes can also be easily clamped in holders for stable alignment. Technical data:...

The SS-024 multimeter test probes have fine tips and are ideal for obtaining plausible test results even in the narrowest of spaces. Based on the safety class CAT III, the test probes can withstand up to 1000 volts or 20 amperes. The...

Isolated Measuring Tip Clamp with 4mm Junction from CCD This Measuring Tip Clamp with 4mm junction suits the professional usage in the automotive diagnosis section . It eases setting safe measuring points (direct setting of the...

The CAN Test Box gives you easy access to the 16 pins of the diagnostic connector that is fitted to all modern vehicles. Depending on the configuration of the vehicle, this may allow you to check power, ground and CAN Bus signal quality....

The 60A clamp is automatically detected by the PicoScope software when it is connected to the oscilloscope, and is automatically set in the software without the need for manual range switching. The current clamp is automatically...

The 2000A current clamp is automatically detected by the PicoScope software when it is connected to the oscilloscope and is automatically set in the software without the need for manual range switching. The current clamp is automatically...

With these pressure probes, pressure curves can be displayed exactly via Texvik. Fuel pressure of electric fuel pumps and their pressure control valves Compression pressure of Otto or diesel engines Oil pressure from the engine or...

Often, problems reported by customers can have many potential causes, and simply reading fault codes leaves you no closer to a solution. In addition to the comprehensive electrical testing provided by PicoScope, the addition of a WPS500X...